All cable terminations must have a thimble and three J-clips.

All cable terminations must have a thimble and three J-clips.

• A. Thimble and three J-clips
• B. Thimble and two J-clips
• C. Eye bolt and nut
• D. Swage and clamps

Answer: (A)

When terminating a wire rope, you protect the rope’s end with a thimble because the thimble creates a smooth, rounded groove that reduces sharp bends and wear where the rope enters the eye. This helps the rope keep its strength and reduces fraying at the termination. The dead end must be secured with clamps—three of them—so the load is evenly shared and there’s redundancy in case one clamp loosens. Using three clamps is standard to prevent slippage and to maintain a secure, durable termination under load. Other options don’t fit this termination method: an eye bolt and nut isn’t a proper rope termination, and swage refers to a different permanent method rather than a thimble plus clamps configuration. Therefore, the combination of a thimble and three J-clips is the correct requirement.

When terminating a wire rope, you protect the rope’s end with a thimble because the thimble creates a smooth, rounded groove that reduces sharp bends and wear where the rope enters the eye. This helps the rope keep its strength and reduces fraying at the termination. The dead end must be secured with clamps—three of them—so the load is evenly shared and there’s redundancy in case one clamp loosens. Using three clamps is standard to prevent slippage and to maintain a secure, durable termination under load. Other options don’t fit this termination method: an eye bolt and nut isn’t a proper rope termination, and swage refers to a different permanent method rather than a thimble plus clamps configuration. Therefore, the combination of a thimble and three J-clips is the correct requirement.